Reach targeting: put audiences on your campaigns
On this page
Targeting puts your audiences on campaigns, ad sets and ad groups, one or many at once. Open it from the sidebar: Reach > Targeting. The page shows the ad accounts of the entity you are on.
Before you start
- The ad account is connected on Setup > Ad accounts. With none connected the page shows No campaigns and Connect an ad account.
- An audience is sent to that ad account on Reach > Audiences. Until then the page says so, with Open audiences.
- You are an Owner or an Admin.
The table
Each row is a campaign, an ad group or an ad set from your connected ad accounts.
- Campaign / Ad group / Ad set: its name, with its campaign or type underneath.
- Platform and ad account: where it runs.
- Status: Active, Paused or Ended, as the platform reports it.
- Tapper audiences: the audiences on it now.
Search by name, or filter by Platform, Ad account and Tapper audience.
Put an audience on a campaign
- Click Attach on the row. To do many at once, tick the rows and click Attach above the table.
- Under Audiences, tick the audiences to put on.
- Under How, choose Target or Exclude. Target: the audience is who the campaign reaches. Exclude: the audience is left out of the campaign.
- Click Put on.
Tapper makes the change in the ad account and the row shows the audience under Tapper audiences. Everything else on the campaign stays as it is.
Take an audience off
Tick the rows, click Detach and confirm with Take off. Everything else on them stays as it is.
Messages you may see
- Send an audience to this ad account on Audiences to use it here: no audience goes to that ad account. Open Reach > Audiences and send one.
- Reconnect this ad account: click Open the ad account and reconnect it.
- This kind of campaign cannot target an audience, or cannot exclude an audience: the platform does not allow it for that kind of campaign, ad set or ad group.
- This one has ended or was removed: there is nothing to change on it.
- This one is part of a test, and the test keeps it as it is: it can take an audience when the test is over.
- This audience is still being built on the platform: try again when its status is Ready.
- The last send of this audience did not go through: open the audience on Reach > Audiences to see why.
- The platform did not accept the change: nothing changed. Check the campaign in the ad platform and try again.
- Another change is being made to this ad account. Try again in a moment: wait and try again.
Related
Was this helpful?
Still need help?
Chat with our team and mention this article.